Monthly Archives: September 2017

Tapered Bench Plane Irons

We are pleased to now offer tapered plane irons to those who wish to build a wooden bench plane.  Input for these iron designs came from two contemporary plane makers:  Steve Voigt of Voigt Planes, and Darryl Gent, who is on Instagram.  These two makers shared their experience and insights about irons, and, in particular, double iron plane making.

Both  These irons are made of O-1 tool steel, and have the same 1/2° taper as the molding plane irons we use in molding planes.  We start with 3/16″ thick stock for all sizes of these irons, with the finished thickness at the cutting edge slightly less than that.  The tang end is approximately 1/8″ thick, depending on which size, as they all have different lengths.

There is the option of a cap iron slot for those wishing to make a double ironed plane.  Slots are all 7/16″ with with a hole at the tang end that is 3/4″ in diameter for the cap screw head to slip through.  Overall slot length is 3 1/4″.

Tapered irons in three sizes, with and without cap iron slots

 

Irons are tapered and beveled, and the tang is profiled.

These irons have been heat treated to a hardness of 60-62 Rc, and given a cryogenic treatment (-300° F).  The cryogenic treatment is meant to reduce internal stresses and improve the wear resistance of the cutting edge.

Currently we are offering three sizes as follows:

Smoothing plane,  1 3/4″ wide by 7″ long.

Jack plane,  2″ wide by 7 1/2″ long.

Jointer Plane,  2 1/2″ wide by 8 1/8″ long.

These irons have not been flattened or sharpened.  They do have a 30° bevel, and the heat treat process was professionally done by a vendor who specializes in blades.  Warping has been in our experience minimal.  The cost of the material and the manufacturing processes of these irons is fairly high, and in an effort to offer them as reasonably priced as possible, we chose to not do any final sharpening.  Also, the customer may want a camber or a radius on their iron, so it makes sense to leave them in this state.

Prices range from $64 for a smoothing iron with no slot to $79 for the jointer iron with a slot.  This is a limited run to test the market, and if there is enough interest, more will be made, and possibly additional sizes.  Available for purchase here.

From left: Jointer, smoother, jack irons.

 

Profiled tang.